1
NOTE : If desired, gather the extra telephone line cord together and store
inside the wall mounting bracket.
4. Slip the mounting holes over the wall plate posts and firmly slide the
unit down into place (wall plate not included).
5. Plug one end of the coiled handset cord into the handset and the
opposite end into the base.
6. Set the RINGER LINE 1 and RINGER LINE 2 volume switches located at
the back of the base to the desired loudness.
• = Telephone will not ring.
•
= Lo - Sound will be lowest.
•
= Hi - Sound will be loudest.
7. Press the Line 1 button if the Line 1 telephone cord is connected.
Otherwise, press the Line 2 button.
8. The unit is properly installed if you pick up the handset and hear the dial
tone. Otherwise, recheck all installation steps.
All manuals and user guides at all-guides.com
4
3
6
7
STORE
A
B
C
OPTIONS
ERASE
DIAL
REVIEW
CONF
HOLD
LINE
VOL
REDIAL
SPEAKER
FLASH
5
13