JB Systems Light SPACE 3 Laser Manual De Instrucciones página 6

ENGLISH
These are the functions available on the CA-8 controller:
 STANDBY button: used to put the laser in blackout (no output). The standby LED
is on during blackout.
 MODE button: used to toggle different modes:
 MODE LED OFF: Laser in full automatic mode. Function button is not used.
 MODE LED ON: Laser in manual pattern select mode. Press the function
button to select one of the built-in patterns.
 MODE LED BLINKING: Laser is in Music controlled mode. Function button is
not used.
5) DMX512 MODE:
The laser can be controlled by any standard DMX-controller.
 Connect the DMX input of the laser to the DMX output of the previous unit in the chain
or directly to the DMX-output of your controller.
 Press the FUNC-button until the display shows a 3 digit number
 Select the desired DMX-address (from 001 to 505)
 Press the ENTER-button to confirm your choice.
The Space3 laser uses 8channels, please refer to the DMX-chart below for the functions
of the different channels.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to "daisy chain" your DMX controller
and all the connected light effects with a good quality XLR
M/F balanced cable. To prevent strange behavior of the light
effects, due to interferences, you must use a 90Ω to 120Ω
terminator at the end of the chain. Never use Y-splitter cables,
this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows
which commands from the controller it has to decode.
JB SYSTEMS
®
USER MANUAL
7/54 SPACE 3 Laser
ENGLISH
DMX-CONFIGURATION OF THE SPACE3 LASER:
CHANNEL VALUE DESCRIPTION
1 000-063 Laser output in blackout
MODE 064-127 Laser in Music controlled mode
SELECT 128-191 Laser in Full automatic mode
192-255 Laser in DMX mode
2 000-063 Pattern Group 1: LINES
PATTERN 064-127 Pattern Group 2: TUNNELS
GROUP 128-191 Pattern Group 3: CURVES
192-255 Pattern Group 4: OTHERS
3 SEE CH2: LINES
PATTERN
SELECT
000-031
032-063
064-095
096-127
128-159
160-191
192-233
234-255
4 000-128 Fixed rotation position of the pattern
ROTATION 129-255 Continuous pattern rotation from slow to fast
5 000-128 Zooming: pattern size (from big to small)
SIZE 129-255 Continuous pattern zooming (from slow to fast)
6 000-128 Pan movement (X-axis: horizontal movement)
PAN 129-255 Pan speed (from slow to fast)
7 000-128 Tilt movement (Y-axis: vertical movement)
TILT 129-255 Tilt speed (from slow to fast)
8 000-085 Original pattern (selected with channels 2+3)
OPTION 086-170 Patterns without blanking (all pattern lines connected together)
171-255 Black out of the laser beam (laser beam OFF)
JB SYSTEMS
®
USER MANUAL
TUNNELS CURVES OTHERS
8/54 SPACE 3 Laser