Minebea Intec Signum YDO0 SW-232 Serie Instrucciones De Instalación página 10

YDO02C
10
Installing the Ethernet Board
§ Fasten the RS-232 interface (including the connector board) into the applicable opening
on the new rear wall panel (bottom): Fasten the 2 screws in the connector mounting.
§ Fasten the interface module (YDO0.SW-ETH - Ethernet port including the connector
board) into the applicable opening on the rear wall panel supplied (top): Fasten the
2 screws in the connector mounting.
§ Connect the ribbon cable: Insert the ribbon cable for Ethernet connection into the
applicable slot on the digital board (on the left in the illustration).
$ Insert the ribbon cable for the RS-232 interface into the applicable slot on the digital
board (on the right in the illustration).
§ Insert the ribbon cable for the Ethernet connection into the applicable slot on the
interface module (YDO0.SW-ETH).
$ Insert the ribbon cable for the RS-232 interface into the applicable slot on the connector
board (on the left in the illustration).
§ Fasten the rear wall panel to the scale: Fasten the 6 screws.
Configuring the Ethernet interface for operation
After installing the interface module in the indicator and configuring it, configure the
Ethernet interface for its intended function with the aid of the operating menu. See the
"Settings" section for this purpose. The "Configuration" section of the Signum operating
instructions contains further explanations about this.