Publicidad
Idiomas disponibles
Idiomas disponibles
DISPENSER STAND
1. Remove the top cover of the dispenser by lifting it a few
millimeters and pulling it out horizontally.
2. Remove the filter and the shaker.
3. Unscrew the tap assembly from the coupling bracket.
Unscrew the inner reservoir nut and remove the nuts and
reservoir gasket.
4. Remove the dispenser support and uncouple the reservoir
by pressing upwards.
Clean all the parts perfectly, as well as the machine block with
water and detergent.
The parts, with the exception of the machine cover, the
dispenser base and the cover, can be put in the dishwasher at
a maximum temperature of 40ºC.
Do not use abrasive products or solvents, as they could damage the compound of the elements of the juicer
system. Do not clean the juicer assembly using pressurized water. Dry the components of the squeezing
system and the machine block.
FAILURE
The machine does not operate. Machine unplugged.
The machine is blocked while
squeezing is in progress.
The machine stops every few
minutes.
POSSIBLE CAUSE
No power.
Transparent cover misplaced.
Defective safe detectors.
Defective ON/OFF button.
Defective electric circuit.
Insufficient voltage.
Wrong fruit size.
Insufficient ventilation.
Insufficient voltage.
Page 19 / 72
E L E V A T I N G C U L I N A R Y E X C E L L E N C E
MAINTENANCE
TROUBLESHOOTING
SOLUTION
Plug it to socket.
Check the plug and socket.
Make sure it is well placed.
Call customer service.
Call customer service.
Call customer service.
Check that the voltage is as
indicated on the identification
label.
Check the size of the fruit is as
shown in this manual.
Check that ventilation gratings
are not covered.
Check the voltage.
Publicidad
