Honda Motor EG1000 Manual Del Propietário página 37

SERVICING YOUR GENERATOR
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete
draining.
1.Place a suitable container below the engine to catch the used oil, and
then remove the oil filler cap, oil drain plug, and sealing washer.
2.Allow the used oil to drain completely, and then reinstall the drain
plug and a new sealing washer. Tighten the plug securely.
Improper disposal of engine oil can be harmful to the environment.
If you change your own oil, please dispose of the used oil properly.
Put it in a sealed container, and take it to a recycling center. Do not
discard it in a trash bin, dump it on the ground, or pour it down the
drain.
3.With the generator in a level surface, fill with the recommended oil to
the upper limit (see page 35).
Engine oil capacity: 0.36 L
4.Reinstall the oil filler cap securely.
Wash your hands with soap and water after handling used oil.
34
OIL FILLER CAP
UPPER LIMIT
SEALING WASHER
(Replace)
OIL DRAIN PLUG