Publicidad
Idiomas disponibles
Idiomas disponibles
7. Attach hutch bracket (F) to the back side of
bookcase hutch using two M6 x 15 mm bolts (G)
through top two slots on bracket. Repeat on
opposite side of bookcase hutch. (See Figure 8)
8. Connect bookcase hutch to cabinet by installing
two ST5 x 20 mm screws (H) through lower holes of
hutch brackets (F). (See Figure 8)
NOTE: ST5 x 20 mm screws (H) can be tightened
using Phillips screwdriver or drill. If using drill,
ensure it is set to lowest clutch setting.
Figure 8
9. Insert shelf dowels (E) in desired locations on
bookcase hutch. Place shelves (5) on top of shelf
dowels. Tighten supports on underside of shelves
for a secure fit. (See Figure 9)
Figure 9
5
5
PAGE 4 OF 12
ASSEMBLY CONTINUED
G
F
H
E
5
1-800-295-5510
uline.com
WALL ANCHOR (OPTIONAL)
1. Attach one bracket of wall anchor to back of top
panel using two M4 x 20 mm screws (I). Mark holes
on wall where plastic anchors are to be located.
Drill holes using 5/16" drill bit. Mount opposite
bracket of wall anchor to wall with two M4 x 40 mm
screws and two plastic anchors (I). Tighten cable tie
to prevent tipping. (See Figure 10)
Figure 10
Top
Wall
Back
0224 IH-11437
Publicidad
