Alltion AC-1000 Serie Manual Del Usuario página 26

Radiated RF
IEC 61000-4-3
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic is affected by absorption and
reflection from structures, objects and people.
a) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones
and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted
theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an
electromagnetic site survey should be considered. If the measured field strength in the location in which the
AC-1000 is used exceeds the applicable RF compliance level above, The AC-1000 should be observed to
verify normal operation. If abnormal performance is observed, additional measures may be necessary, such
as reorienting or relocating the AC-1000.
b) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3V/m.
3 V/m
80 MHz to 2.7 GHz
where p is the maximum output power rating
of the transmitter in watts (W) according to the
transmitter manufacturer and
recommended separation distance in metres
3 V/m
(m).
80 MHz to 2.7
GHz
Field strengths from fixed RF transmitters, as
determined
survey,
level in each frequency range.
Interference may occur in the vicinity of
equipment marked with the following symbol:
22
b
by an electromagnetic
a
should be less than the compliance
d is the
site