CASO DESIGN AF150 Manual Del Usuario página 28

10.3.3 Dangers due to electrical power
Danger
Mortal danger due to electrical power!
Mortal danger exists when coming into contact with live wires or subassemblies!
Observe the following safety notices to avoid dangers due to electrical power:
► Avoid any liquid getting into the device to avoid an electrical shock or short circuit.
► If the connection lead is damaged, you will need to have a special connection lead
installed by an authorized electrician.
► Do not operate this device if its power cable or plug is damaged, if it does not work
properly or if it is damaged or has been dropped. If the power cable is damaged, it will
need to be replaced by the manufacturer or his service agency or a similar qualified
person, to avoid any dangers.
► Do not open the housing on the device under any circumstances. There is a danger of
an electrical shock if live connections are touched and the electrical or mechanical
structure is altered. In addition, functional faults on the device can also occur.
► Do not submerge the heating unit, cord or plug in water or other liquids to prevent
electrical shock.
11 Commissioning
This chapter provides you with important safety notices during the initial commissioning of
the device. Observe the following notices to avoid dangers and damages:
11.1 Safety information
Warning
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
► Packaging materials may not be used for playing. There is a danger of suffocation.
11.2 Delivery scope and transport inspection
As a rule, the Fryer is delivered with the following components:
 Fryer  Frying basket with handle
 Frying pot  Power cord
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
11.3 Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 The device must be set up on a firm, flat, horizontal and heat resistant surface with
sufficient load-bearing capacity for the device.
caso AF150
 Operating Instructions
28