CASO DESIGN AF150 Manual Del Usuario página 29

 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm on all sides.
 Do not cover up any openings on the device and do not block these off.
 Do not remove the device's adjustable feet.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
11.4 Unpacking
To unpack the device, proceed as follows:
 Place the box containing the unit on a countertop or table.
 Remove the device from the box and remove the outer packaging.
 Remove all the stickers or labels (except for the rating plate!).
11.5 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.
11.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
Do not use an extension lead. If you accept liability for doing so, only use an extension
lead which is in good condition and is suited to the power of the appliance.
 The use of multiple plugs or gangs is prohibited because of the danger of fire that is
involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
caso AF150 29