Publicidad
Idiomas disponibles
Idiomas disponibles
4.3 Programming of Tubular with electronic end stop
Ignition - will
Press the
emit a sound
P2 key using
three beeps.
a pencil.
Make a brief.
Beep and
open and STOP
short rotation
manoeuvre
Upper
limit
Press again Stop key for 5
To confirm the
seconds.
position of the
The motor will emit a sound 3
roller blind,
beeps, followed by a short
press the Stop
rotation.
key.
The superior limit is memorised.
4.4 Removing an end stop
Ignition - will emit a
Press the P2 key
sound three beeps.
once.
Make a brief.
open/close and
STOP
4.5 Programming intermediate position
Important !
Only after programming the upper and lower limit, it is possible to program the intermediate position.
Upper limit
and lower limit
programmed.
Press the P2 key
Press the
The motor will emit a
UP key.
sound 1 beeps,
Beep and
followed by a short
short
rotation.
Programming
rotation
occurred.
Loweer limit
adjustment
For an accurate
adjustment press the
Down keys to bring the
roller blind in the
desired closing position.
Press the Down
key once.
Each press the engine will emit 1 beep
To program any
intermediate position to
give an opening impulse
UP. Press P2 at the
desired position. The
engine stops, emits 1
beep and short rotation
and stop.
Upper limit
adjustment
For an accurate adjustment press the
UP keys to bring the roller blind to the
desired opening position.
To confirm the
position of the
roller blind,
press the Stop
key.
Press the P2 key
once.
Press the Stop button
for 1 time. The motor
will
emit
1
beep
followed
by
1
short
rotation of the motor.
Lower
limit
Press again Stop key for
5 seconds.
The motor will emit a
sound 3 beeps, followed
by a short rotation.
The inferior limit is
memorised.
The motor will emit
three beeps followed
by a short rotation.
OK
Press the Stop button again.
The engine will emit 3 beeps and
3 short rotations to signal that the
Position has been memorized.
11
Publicidad
