Publicidad
Idiomas disponibles
Idiomas disponibles
To reach the upper position, press UP
To to reach the down position press DOWN
To activate the intermediate position hold STOP for 3 seconds.
4.6 Additional remote control
A maximum of 20 remote controls may be associated with a motor.
Ignition – Make a brief open/close
and STOP manoeuvre.
The minimum time necessary for ignition is 5s. Press the UP/DOWN control before proceeding with the deletion
procedure if the power is turned off and back on.
4.7 One-channel remote control TOTAL deletion procedure
• SMS wireless tubular motor (without emergency manoeuvre function)
Motor powered - Make a brief opening / closing and stop maneuver -
Press the P2 button once, the Stop button once and the P2 button
once again. Each press the engine will emit 1 beep and short
maneuver.
The elimination of the remote controls does not cancel the
positions of the limit switches and the intermediate position
(via wire). To delete, carry out a new programming via remote
control
4.8 Five-channel remote control deletion procedure
Remember to select the required channel using the RIGHT or LEFT button before deleting each channel following the method
described above for the SMS models. The LED corresponding to the selected channel will light up.
Warning: Press the UP/DOWN control before proceeding with the deletion procedure if the power is turned off and back on.
12
Remote control "a" already memorized - "b" to memorize
a
Press quickly for 2
Press once the
P2 key of the "b"
times the P2 key of
the "a" remote
remote control.
control.
Repeat P2 on the
remote control "a".
Each press the
engine will emit 1
beep
Remote control
addition OK.
b
The motor will emit
three beeps
followed by a short
rotation.
Three beeps will be heard followed by the
motor turning briefly in the up/down
(opening/closing)
successful deletion.
directions
to
confirm
Publicidad
