Publicidad
Idiomas disponibles
Idiomas disponibles
4.9.0 Change of motor rotation direction (ONLY FOR SERIE 45SMS-RS)
After the change of the rotation direction,
the
limits
end
reprogrammed again.
Ignition
Press the UP key of
the remote control.
The motor will
operate in ascent.
4.9.1 Change of motor rotation direction (ONLY FOR 59SMS-RS SERIES)
Perform the procedure described in paragraph 4.1, with the variation of the DOWN key instead of UP in the sequence indicated.
5. PROBLEM RESOLUTION
Problem
At first ignition, the motor functions slowly
or is blocked.
The motor stops in ascent/descent before
the stop limit.
At every ascent command, the motor
moves for a short interval and then
arrests.
6. DECLARATION OF CONFORMITY TO DIRECTIVE 2014/53/EU RED
Hereby Aprimatic s.r.l., declares that the Wireless Tubular Motors with following codes
are in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU RED.
The declaration of conformity may be consulted at
Service
stop
limits
may
be
Programming key
Press the Stop
key to arrest the
motor.
Possible cause
• Incorrect power supply
• Erroneous connections
• High load
• Incorrect installation
• Excessive strain
• Thermal protection intervention
The data related to the stop limit and the
position of the table-top conveyor is
damaged.
Product Code
43812/002
43812/003
43822/001
43822/002
43822/003
www.aprimatic.it
To restore changes in rotation or direction,
repeat the below operations.
Press and hold the key
located on the motor head
until the latter emits three
beeps and makes a short
rotation.
• Check the plate for the power supply
• Check the circuit and connections
• Check for possible frictions in the
• Re-install the motor
•
•
Follow the procedure for the removal and
reprogramming of the end limit.
Type model
45 SMS MP-RS 30 Nm
45 SMS MP-RS 50 Nm
59 SMS MP-RS 80 Nm
59 SMS MP-RS 100 Nm
59 SMS MP-RS 120 Nm
or can be requested to the Aprimatic Customer
Press the UP key of
the remote control.
The motor will
operate in descent
Solution
system an/or the correct choice of the
motor torque with the weight to be
lifted
Check for obstacles in the normal
sliding of the rolling tube
Wait for the motor to cool for
approximately 20 minutes
13
Publicidad
