Beha-Amprobe ACD-14-PRO Manual Del Usuario página 8

F
Direct Current (DC).
N
Battery.
Underwriters Laboratories. [Note: Canadian and US.]
P
Complies with European Directives.
Conforms to relevant Australian standards.
Do not dispose this product as unsorted municipal waste.
=
Contact aqualified recycler.
SAFETY INFORMATION
The meter complies with:
• UL/IEC/EN 61010-1, CAN/CSA C22.2 No. 61010-1, Pollution Degree 2,
Measurement category III 600 V
• IEC/EN 61010-2-033
• IEC/EN 61010-2-032
• IEC/EN 61010-031 (test leads)
• EMC IEC/EN 61326-1
Measurement Category III (CAT III) is for equipment intended to form part
of a building wiring installation. Such equipment includes socket outlets,
fuse panels, and some mains installation control equipment.
CENELEC Directives
The instruments conform to CENELEC Low-voltage directive 2006/95/EC and
Electromagnetic compatibility directive 2004/108/EC.
W Warning: Read Before Using
To avoid possible electric shock or personal injury:
• Use the meter only as specified in this manual or the protection
provided by the meter might be impaired.
• Avoid working alone so assistance can be rendered.
• Do not use the meter in wet or dirty environments.
• Do not use the meter if it appears damaged. Inspect the meter before
use. Look for cracks or missing plastic. Pay particular attention to the
insulation around the connectors.
• Inspect the test leads before use. Do not use them if insulation is
damaged or metal is exposed.
• Check the test leads for continuity. Replace damaged test leads before
using the meter.
• Have the meter serviced only by qualified service personnel.
• Use extreme caution when working around bare conductors or bus
bars. Contact with the conductor could result in electric shock.
• Do not hold the meter anywhere beyond the tactile barrier.
• When measuring current, center the conductor in the clamp.
• Do not apply more than the rated voltage, as marked on the meter,
between the terminals or between any terminal and earth ground.
4