Pride Mobility MID-SIZE Serie Manual Del Proprietário página 30

To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the bottom
of the seat base. See fi gure 19.
3. Use a wrench to remove the two rear bolts that attach the
seat frame to the seat base.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts back into the
seat frame.
5. Tighten the bolts.
Metal tab style positioning belt
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into the
plastic housing on the opposite strap until you hear a "click."
See fi gure 20.
2. Pull the strap on the right side of the belt until it is secure,
but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
Reusable hook and loop fastener style positioning belt
To adjust the positioning belt for operator comfort:
1. Align the two sides of the belt placing the looped-end side directly above the coarser side ("hook") of the opposite
belt. Press fi rmly together to fasten. See fi gure 20.
To release the positioning belt:
1. Grasp the looped-end side of the belt and pull up to detach from the other side of the belt.
MANDATORY! Make sure the positioning belt is properly secured to the scooter and is adjusted
for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose parts or damage, including tears, worn spots,
bent hardware, or damaged latch mechanisms, dirt or debris, before each use of the scooter. If
you discover a problem, contact your authorized Provider for maintenance and repair.
30
V. C O M F O R T A D J U S T M E N T S
OR
Figure 20. Positioning Belt - Metal Tab Style or
Reusable Hook and Loop Fastener Style
Mid-size Scooter Series