Disassembly And Assembly - Pride Mobility MID-SIZE Serie Manual Del Proprietário

V I . D I S A S S E M B LY A N D A S S E M B LY
DISASSEMBLY
You can disassemble the scooter into several pieces: the seat, the rear section, the front section, the basket, the
batteries, and the battery shroud. See fi gure 21. No tools are required to disassemble or assemble your scooter,
but keep in mind that the disassembled sections of the scooter take up more fl oor space than the assembled unit.
Always disassemble or assemble your scooter on a level, dry surface with suffi cient room for you to work and
move around your scooter—about 5 feet (1.5 meters) in all directions. Remember that some scooter components
are heavy and you may need assistance when lifting them.
WARNING! Do not lift beyond your physical capability. Ask for assistance when necessary while
disassembling or assembling your scooter.
WARNING! Do not pick up the seat frame or scooter by the armrests. They are free to pivot, and
you may lose control of the seat if they do so.
IDENTIFICATION
KEY
1. SEAT
2. REAR SECTION
3. FRONT SECTION
4. BASKET
5. BATTERIES
6. BATTERY SHROUD
Figure 21. Disassembled Scooter
DISASSEMBLY PROCEDURES
1. Remove the key from the key switch. For model 104, lock the tiller
in the straight ahead position by pushing the tiller lock knob in and
turning it clockwise 90°. See fi gure 22. The front wheel must face
forward in order to lock the tiller.
2. Remove the seat by lifting it straight up and off of the scooter. If
you encounter resistance when removing the seat, disengage the seat
rotation lever and swivel the seat back and forth while lifting up on
the seat.
3. Gently pull the battery shroud forward, then lift up and off of the
scooter. See fi gure 10.
4. Disconnect the battery tie-down strap. See fi gure 11.
5. Unplug both battery harnesses by depressing the tabs and then
pulling each harness straight up. See fi gure 11.
6. Remove the batteries from the battery wells.
WARNING! Failure to unplug both battery harnesses
prior to separating the front and rear sections could
result in permanent damage to the scooter.
7. For model 104, you also need to disconnect both front-to-rear
harnesses. See fi gure 11.
WARNING! Failure to unplug both front-to-rear harnesses
prior to separating the front and rear sections could
result in permanent damage to the scooter.
NOTE: Please check the Scooter Features Table on the inside of the front cover to determine if your scooter
has a frame release lever or a lockup pin before attempting to separate the frame.
Mid-size Scooter Series
1 2
3
4
Figure 22. Tiller Lock Knob (Model 104
only)
5 6
31