Daily Maintenance; Error Codes - AGP R16 Instrucciones De Seguridad

Daily Maintenance

1.
Keep the machine clean
2.
Check to ensure that the motor coupling cable, power supply cables and water coupling hoses are in
good condition.
3. Ensure all screws are tight.
4.
Check the condition of all safety equipment such as the blade guard
5.
Check the blade for damage.
6.
Ensure that the guide tensioners and drive tensioner are properly adjusted.
If the replacement of the power supply cord is necessary, this has to be done by the manufacturer or
their agent in order to avoid a safety hazard.
WARNING: All repairs must be entrusted to an authorized service center. Incorrectly performed repairs
could lead to injury or death.
Do not throw electric power tools into the household waste!
In accordance with the European Directive 2002/96/EG on Waste Electrical and Electronic Equipment and
transposition into national law, used electric power tools must be collected separately and recycled in an
environmentally friendly manner.
POWER CONVERTER LCD SCREEN CODES:
OFF: When the converter is plugged in, the screen will display the supply voltage. The voltage displayed will
depend on the voltage of the supply
ON: When the converter power button is pressed, the screen will display "ON" The connected tool is now live

ERROR CODES

Loss of communication between
the motor electronics board, the
8888 converter electronics board and
the LCD module when powering
up
E1 Overload of the converter.
E2 Overheat of the converter
E3 Under voltage
E4 Over voltage
GB
Check the connection of the coupling cable
At the tool, turn the switch OFF and then ON again
Ensure that water is flowing.
As soon as temperature returns to normal, at the tool, turn
the switch OFF and then ON again
As soon as supply voltage returns to normal, at the tool,
turn the switch OFF and then ON again
As soon as supply voltage returns to normal, at the tool,
turn the switch OFF and then ON
15