Publicidad
Idiomas disponibles
Idiomas disponibles
DOOR SWING
Moving the hinges allows the door to open from either
the left or the right side. Change the swing BEFORE
attaching the door panel.
To change:
1. Open the door. Remove 4 stainless steel screws
opposite the hinge side on the front of the cabinet.
2. Remove innermost screw holding each hinge to the
Remove
3. Slide the door to the side so the keyhole on the
hinge clears the screw and remove from cabinet.
4. Remove the screws that were loosened and save.
Install the 4 stainless steel screws that were
removed in Step 1 into the open holes on the
cabinet left by removing the hinge.
5. Remove the hole plug and hinge opening covers
Hole plug
Hinge Opening Cover
6. Remove hole plugs or screws from unit's new hinge
7. Install the 2 hinge screws removed after the door
was removed from the cabinet into the outermost
holes on the new hinge side of the cabinet. Screw
these in only about half way.
8. Remove the upper hinge from the door and move it
to the door's opposite side, bottom location. Secure
using the original screws.
NOTE: If door panel is attached, it must be
removed to access hinge screws and to reverse
the handle position.
49-1000437 Rev. 0
Installation Instructions
9. Remove the original lower door hinge and move it
to the opposite side, upper location. Secure using
original screws.
IMPORTANT: If installing a stainless steel door
panel or custom panel, skip to INSTALLING THE
DOOR PANEL section.
11. Place the keyhole slot on the hinge over the
outermost screw, top and bottom, and slide the
door onto the cabinet.
12. Install the door to the cabinet using the original
screws. Tighten all 4 screws.
IMPORTANT: In some situations the door can
open too far and damage adjacent cabinets. To
into the provided hole in the top and bottom hinges.
Drive the pin into the hole until the head is flush
with the hinge.
Door stop pin
13. Slide the hinge covers from the hardware packet
over each hinge.
Side
Cover
14. Attach the side covers from the hardware packet
over the hinge by peeling off the covering over the
adhesive and placing it over the side of the hinge.
NOTE: If the unit is being built-in a screw can be
used to secure the unit to the cabinet in place of
installing the side covers.
Hinge Cover
11
Publicidad
