Publicidad
Idiomas disponibles
Idiomas disponibles
Bracket x 2
1.
Insert caster into slots at the ends of bracket. Secure
with one 1/4" flange bolt and one 1/4" flange nut per
caster. Tighten with with 10 and 11 mm wrenches
(See Figure 2)
Figure 2
PAGE 2 OF 15
MOBILE PEDESTAL PARTS
Floor Mount Stand x 2
5/8" Bolt x 1
5/16" Carriage Bolt x 7
5/16" Flange Nut x 7
MOBILE PEDESTAL ASSEMBLY
Upright Mount x 1
Hardware Kit
Washer x 1
1/4" Flange Bolt x 2
1/4" Flange Nut x 2
Pedestal Handle x 1
2. Insert two 5/16" carriage bolts through inner holes on
bracket, floor mount stands and bracket with casters.
Secure with 5/16" flange nuts (See Figure 3)
NOTE: Do not fully tighten nuts until step 4 is
complete.
Figure 3
5/8" Nut x 1
3/8" Bolt x 1
Caster x 2
0524 IH-9924
Publicidad
