Uline H-9924 Manual Del Usuario página 3

3. Insert 5/16" carriage bolts through holes on ends of
brackets. Secure with 5/16" flange nuts. (See Figure 4)
Figure 4
4. Insert upright mount into top opening of the
brackets. Secure using one 5/16" carriage bolt and
5/16 flange nut through bottom middle hole. Use
two 5/16" carriage bolts and flange nuts through
remaining square holes at top of brackets.
(See Figure 5)
Figure 5
Upright Mount
5/16" Carriage Bolt
5. Tighten all nuts with 13 mm wrench.
PAGE 3 OF 15
MOBILE PEDESTAL ASSEMBLY CONTINUED
5/16"
Flange Nut
6. Attach yoke to upright mount with 5/8" bolt through
center hole on yoke, washer and pedestal. Secure
with 5/8" nut. Tighten with 24 mm socket wrench.
(See Figure 6)
Yoke
Washer
5/8" Nut
7. Attach pedestal handle to outside of yoke with
3/8" bolt through side hole on yoke. Tighten with
16 mm wrench. (See Figure 7)
Figure 7
Figure 6
Upright Mount
0524 IH-9924