Descargar Imprimir esta página

Husqvarna YTH21546 Manual De Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 13 .
5. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
To use the throttle control
The operating efficiency of the engine decreases
when the engine operates at less than full speed.
Full speed gives the best mower performance.
Set the throttle control (A) to the "FULL" position
to operate the engine at full speed.
A
To use the choke control
Note:
Use the choke control to start a cold engine.
Do not use the choke control to start a warm engine.
A
1. Pull the knob (A) out to engage the choke
control.
2. Push the knob (A) slowly to disengage the choke
control.
To use the cruise control
Only use the cruise control for forward travel on
smooth, straight surfaces. The cruise control will
disengage automatically if the conditions for cruise
control become unsatisfactory.
1963 - 002 - 13.10.2022
1. Push the forward drive pedal (B) down. Keep the
forward drive pedal in a position that gives the
correct speed for the terrain.
A
2. Pull the cruise control lever (A) up and hold it
while you release the forward drive pedal.
3. Release the cruise control lever to engage the
cruise control.
4. Push the brake pedal or tap on the forward drive
pedal to disengage the cruise control.
To use the headlight
Push the power switch to position (A) to make
the headlight come on.
B
Push the power switch to position (B) to make
the headlight go off.
To engage and disengage the
cutting deck
WARNING:
cutting deck without a deflector or grass
catcher installed to the grass discharge.
The product has an operator presence control
(OPC). When you go away from the seat with the
engine on and the cutting deck engaged, the engine
stops.
Stay fully and in the center of the seat to make sure
that the engine operates correctly and does not stop
on rough terrain or hills.
1. Set the correct cutting height. Refer to
cutting height on page 14 .
B
A
Do not operate the
To set the
15

Publicidad

loading