LEXMAN 87554450 Manual De Instrucciones página 112

2. DISMANTLING
OFF
OFF
EN
When replacing the motor, take care to protect the electric cable to avoid damaging it
when removing and inserting the motor into the shutter shaft.
112
Lower the roller shutter and switch off the power supply before dismant-
ling.
1
Warning: Do not forget to turn
off the circuit breaker before
carrying out this step, as failure to
comply with the above recom-
mendation may result in risks to
OFF
life and limb.
1 - Using pliers, cut the cables of the
motor to be replaced, or disconnect it if
it is connected via connectors/joints.
2 - Completely remove the current mo-
tor from the shaft so that the new motor
can be positioned.
2