Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
CONTROL PANEL BUTTONS
1. Power button: Press to turn the dehumidifier on or off.
• Press and hold for 3 seconds to engage Wireless Connection.
2. Timer button: Press to set the timer.
3. Mode button: Press to select the desired mode. Set, Continuous, Dryer, Comfort.
4. Humidity adjust buttons: Press to set humidity level or set timer.
5. Fan Speed button: Press to select fan speed. Low, High.
• Press and hold the the Fan button for 3 seconds after cleaning the air filter. The check filter light will
illuminate after 250 hours of operation.
6. Display: Shows the actual (± 5% accuracy) room humidity level in a range of 30% to 90%. Otherwise,
displays error codes or selection when programming humidity or timer.
7. Pump Button: Press to engage the pump feature.
Note: The pump drain hose MUST be installed to ensure there is no water leakage onto the floor when
using the Pump Mode.
CONTROL PANEL LIGHTS
A.
Timer: Illuminates when a timer has been set.
B.
Set: Illuminates when setting dehumidifier parameters.
C.
Continuous: Illuminates when the unit has been set to continuous dehumidification. The
dehumidify function runs continuously regardless of the actual humidity. A desired humidity level
can not be set in this mode.
D.
Dryer: Illuminates when unit has been set in dryer mode. A desired humidity level
can not be set in this mode.
E.
Comfort: Illuminates when unit has been set to comfort mode. A desired humidity level can not be
set in this mode.
Bucket Full: Illuminates when the internal water bucket is full. The unit will stop dehumidifying
F.
and the error P2 will appear in the display. Once emptied, the unit will return to the previous
settings.
G.
Fan Speed: Illuminates to indicate the selected fan speed.
H.
Filter: Illuminates when the filter requires cleaning.
I.
Wireless Connection: Illuminates when the unit is connected to the wireless network.
Pump: Illuminates when the pump function is selected.
J.
13
Publicidad
