Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
3. Pump Drainage
Water can be removed using the pump function and the provided hose.
Before using any automatic drain functions, check that all drain ports are clean. There is one drain port
inside the bucket compartment of the appliance, remove the bucket to see it. There is one drain port on the
back of the appliance where the provided pump hose is attached. All drain ports should be cleaned with a
pipe cleaner prior to use.
To connect the pump drain hose:
• Press the tightening ring of the drainage joint (see fig.1).
• Keep pressing the grey ring while pulling out the plug (see fig.2).
• Insert the drain hose onto the drainage joint, ensure it is connected well so that it is fully seated.
• Place the other end of the drain hose in the locatioon where the water is to drain (e.g. floor drain,
water container, through a window to the outdoors).
To remove the pump drain hose:
• Press the tightening ring of the drainage joint.
• Pull out the drain hose.
• Place the plug back into the joint.
Notes:
• The maximum distance and rise of the pump hose is 16 feet (5m). Exceeding this distance may damage
the unit or cause leaks.
• If removing the hose to use in bucket mode, please re-insert the drain plug to prevent accidental water
leakage. It is still required to press the tightening ring when removing the hose.
IMPORTANT: If the drain pump is activated, water will exit the drain whether a hose is attached or not.
Ensure that the drain pump is deactivated when the hose is removed to avoid damage to the floor due to
leaking water.
WIRELESS CONNECTION
This appliance can be controlled with a wireless application on your wireless device.
Visit https://www.danby.com/support/apps to download the application and learn about its operation.
• Press and hold the POWER button for 3 seconds to initiate the Wireless connection mode. The LED
DISPLAY shows 'AP" to indicate you can set the wireless connection.
• If connection is successful within 8 minutes, the unit will exit Wireless connection mode automatically,
the Wireless indicator illuminates and the unit enters the previous function. If the connection fails within
8 minutes, the unit exits the wireless connection mode automatically.
17
Publicidad
