Publicidad
Idiomas disponibles
Idiomas disponibles
MODELS:
WARNING:
If you do not
follow these
instructions
exactly, a fire
or explosion
may result
causing
property
damage,
personal
injury or loss
of life.
1.
STOP! Read the information on the safety label.
2.
Set thermostat to lowest setting.
3.
Turn off all electric power to the appliance.
4.
This appliance is equipped with an ignition device which
automatically lights the pilot. DO NOT try to light the pilot
by hand.
5.
Remove lower front panel.
6.
Push in gas control knob slightly & turn clockwise
to "OFF".
Gas Control Knob
7.
Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP!
Follow "B" in the information on the safety label. If you
don't smell gas, go to the next step.
1.
Turn thermostat to it's lowest setting.
2.
Turn off all electric power to the appliance if service is to
be performed.
3.
Remove lower front panel.
1018028-C
LIGHTING INSTRUCTIONS
DVCF407C-H / DVCF408C-H / DVCF557C-H / DVCF558C-H
FOR YOUR SAFETY READ BEFORE LIGHTING
A.
This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
B.
BEFORE OPERATING, smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• DO NOT try to light any appliance.
• DO NOT touch any electric switch.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
LIGHTING INSTRUCTIONS
NOTE:
Knob cannot be
turned to "OFF"
unless knob is
pushed in slightly.
Do not force.
TURNING OFF GAS TO APPLIANCE
• If you cannot reach your gas supplier, call
the fire department.
C.
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair
it, call a qualified service technician. Force
or attempted repair may result in a fire or
explosion.
D.
Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance
and to replace any part of the control system
and any gas control which has been under
water.
8.
Turn gas control knob counterclockwise
9.
Replace lower front panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions
"TO TURN OFF GAS TO APPLIANCE" and call your
service technician or gas supplier.
4.
Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
5.
Replace lower front panel.
Page 10
Gas Control Knob
to "ON".
Publicidad
