Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: These kits must be installed by a qualified installer or service technician.
FIG. 12-A
31300-A: CABINET TRIM KIT
PART DESCRIPTION
48" Long Side Flange . . . . . . . . . . . . . . . . . . . . . . . . . . . . Qty. 4
TOP
15-1/2" Wide Top Flange . . . . . . . . . . . . . . . . . . . . . . . . . . Qty. 1
FLANGE
#8 Phillips Head Screws . . . . . . . . . . . . . . . . . . . . . . . . . Qty. 10
Units with Terminal Board
1.
2.
3.
LONG
SIDE
FLANGE
Install top flange and secure with two (2) screws.
Select one of the remaining side flanges and position as shown in
Figure 12-B (below), making sure that the side with holes is held against
the side of the furnace (and that the flange is flush with the bottom of the
top trim piece).
Mark these holes and removed side flange. Drill the marked holes with No.
30 drill bit. Re-position flange and secure with screws provided.
Measure from the bottom of the side flange you have just installed to the
floor. Cut one of the remaining side flanges to the measurement and install
as in step 2.
Repeat steps 2 and 3 for opposite side of furnace.
FIG. 12-B
Page 15
QUANTITY
F U
R N
A C
E
PART NO.
31310
31320
50134
Vent
Pipe
Trim
Kit Top
Flange
Wall
Stud
Wall
Trim Kit
Side
Flange
1018028-C
Publicidad
