Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting (continued)
Problem
Possible Cause
Burner(s) will not light
•Faulty electronic ignition circuit.
using ignitor.
•Sparking somewhere other than
Burner(s) will not
•See "GAS ISSUES:" on previous page.
match light.
•Improper method of match-lighting.
Sudden drop in gas
•Out of gas.
flow or low flame.
•Excess flow valve tripped.
•Vapor lock at coupling nut/LP tank
Flames blow out.
•High or gusting winds.
•Low on LP gas.
•Excess flow valve tripped.
Flare-up.
•Grease buildup.
•Excessive fat in meat.
•Excessive cooking temperature.
Persistent grease fire.
•Grease trapped by food buildup around
Flashback...
•Burner and/or burner tubes are blocked.
(fire in burner tube(s)).
Unable to fill LP tank.
•Some dealers have older fill nozzles
One burner does not
•Grease buildup or food particles in
light from other
burner(s).
AUTO-CLEAN™
(If Equipped)
Timer does not work
(Green light does not
flash)
No LED's will illuminate
Red LED next to battery
symbol is illuminated
24
between burner and electrode.
connection.
burner system.
with worn threads.
end(s) of carryover tube(s).
Possible Cause
Dead Battery
Ÿ
Batteries installed incorrectly.
Ÿ
Knob Position did not start the Clean
Ÿ
Cycle
Dead Battery
Ÿ
Low Battery Strength
Ÿ
Prevention/Solution
•See Troubleshooting Integrated Electronic Ignition section.
•Inspect wire insulation and proper connections. Replace wires if
insulation is broken.
•See "Match-Lighting" section of Use and Care.
•Check for gas in LP tank.
•Turn off knobs, wait 30 seconds and light grill. If flames are still low,
turn off knobs and LP tank valve. Disconnect regulator. Reconnect
regulator and leak-test. Turn on LP tank valve, wait 30 seconds and
then light grill.
•Turn off knobs and LP tank valve. Disconnect coupling nut from
tank. Reconnect and retry.
•Turn front of grill to face wind or increase flame height.
•Refill LP tank.
•Refer to "Sudden drop in gas flow" above.
•Clean burners and inside of grill/firebox.
•Trim fat from meat before grilling.
•Adjust (lower) temperature accordingly.
•Turn knobs to OFF. Turn gas off at LP tank. Leave lid in position and
let fire burn out. After grill cools, remove and clean all parts.
•Turn knobs to OFF. Clean burner and/or burner tubes. See burner
cleaning section of Use and Care manual.
•The worn nozzles don't have enough "bite" to engage the valve. Try
a second LP dealer.
•Clean carry-over tube(s) with wire brush.
Prevention/Solution
Replace Batteries
Ÿ
Install batteries correctly.
Ÿ
Push Knob in to start the clean cycle. (Green LED should begin to
Ÿ
flash)
Replace Batteries
Ÿ
Prepare to replace batteries (NOTE: Clean cycle will operate with
Ÿ
a weak battery.
Publicidad
