Publicidad
Idiomas disponibles
Idiomas disponibles
connected to the outside wall.
-
After installation, ensure that the kitchen hood is level to prevent grease build-up on the
end (Fig. 2).
1.
The kitchen hood should be placed at a distance of 65-75 cm above the cooking surface
for best effect (Fig. 3).
2.
The dimensions of the kitchen hood are shown in the following figures:
Figure 4 > 02865_Bolero Flux IM 523500 Inox A
Figure 5 > 02867_Bolero Flux IM 756500 Inox A
3.
Drill a rectangular hole in the enclosure according to the following dimensions (Fig. 6):
02865 > 485 x 275 x 240 mm (width x depth x height)
02867 > 715 x 275 x 240 mm (width x depth x height)
4.
Remove the mesh filters, place the kitchen hood inside the cabinet through the hole, use
the supplied screws ST4*40 (x8) to fix the hood in the cabinet, from the left side, right
side and from the top, as shown in figure 7.
5.
Drill holes and attach the hood.
6.
Once the kitchen hood has been hung up, you can install the flexible chimney connection
pipe to the ventilation duct at the top.
7.
Connect the other end of the flexible connection pipe to the wall chimney.
8.
Plug the power cable into the outlet.
Black cable (or brown, depending on models) > Phase
Blue cable > neutral
Yellow-Green cable > ground
You must connect the phase and neutral cables to a 220-240 V~/ 50 Hz power cable.
The kitchen hood must be connected to an earthed installation.
4. OPERATION
Push buttons
1.
Press the power button, the motor will stop.
2.
Press the low speed button, the kitchen hood will beep, and the motor will operate at low
speed.
3.
Press the medium speed button, the kitchen hood will beep, and the motor will operate
at medium speed.
4.
Press the high power button, the kitchen hood will beep, and the motor will operate at
high speed.
BOLERO FLUX IM 523500 INOX A / IM 756500 INOX A
ENGLISH
47
Publicidad
