Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL INFORMATION
This chapter contains general information which all users of the
users of the manual is provided in subsequent chapters (" IN-
STRUCTIONS FOR .... " ).
1 APPLIANCE SPECIFICATIONS
• The appliance data plate is located inside the control panel.
• The appliance model and serial number are detailed on de-
cals and on the packaging.
2 GENERAL PRESCRIPTIONS
The manufacturer will not be liable for any damage or in-
jury resulting from failure to observe the following rules.
REMINDERS FOR THE INSTALLER
• Read this manual carefully. It provides important information
for safe installation, use and maintenance of the appliance.
•
authorized by the manufacturer, in compliance with current
safety standards and the instructions given in this manual.
• The appliance must be installed in a well-ventilated room.
•
detailed on the packaging and on the appliance data plate.
• Do not obstruct any air vents or drains present on the ap-
pliance.
• Do not tamper with appliance components.
• This type of appliance is intended for commercial applica-
tions: kitchens of restaurants, canteens, hospitals, and shops
such as bakeries, butchers and similar. It is however not in-
tended for continuous mass food production.
WARNING: Opening the drain valve will cause the hot
tank content to escape.
• Before pouring in oil make sure that there is no water in the
well.
REMINDERS FOR THE MAINTENANCE TECHNICIAN
• Read this manual carefully. It provides important information
for safe installation, use and maintenance of the appliance.
•
authorized by the manufacturer, in compliance with current
safety standards and the instructions given in this manual.
•
detailed on the packaging and on the appliance data plate.
• The appliance must be installed in a well-ventilated room.
• Do not obstruct any air vents or drains present on the ap-
pliance.
• Do not tamper with appliance components.
REMINDERS FOR CLEANING
• Clean the external satin stainless steel surfaces, the inside of
the cooking tanks and the cooking plates daily.
• The internal appliance components must be cleaned by a
specialist technician at least twice a year.
• Do not clean the appliance with high pressure water jets or
steam cleaners.
•
base underneath the appliance.
•
in the dishwasher.
•
3 SAFETY AND CONTROL DEVICES
SAFETY THERMOSTAT
The manufacturer will not be liable for any damage or in-
jury resulting from failure to observe the following rules.
• The appliance is equipped with a manual reset safety ther-
mostat which interrupts heating when the operating tempera-
ture exceeds the maximum permitted value.
• To restore appliance operation, press the thermostat reset
button. This procedure must only be carried out by a quali-
4 DISPOSAL OF PACKAGING AND THE APPLIANCE
PACKAGING
The packaging is made using environmentally friendly mate-
rials. The plastic recyclable components are:
• the transparent cover, the bags containing the instructions
manual and nozzles ( made of polyethylene - PE.).
-
• the straps (in polypropylene - PP).
APPLIANCE
The appliance is manufactured 90% from recyclable metals
(stainless steel, aluminum sheet, copper.... ).
The appliance must be scrapped in compliance with current
regulations governing such disposal.
• It must be disposed of properly.
• Make the appliance unusable before scrapping.
5 RISKS DUE TO NOISE
• As regards airborne acoustical noise emissions, the A-
weighted sound pressure level is below 70 dB(A).
INSTRUCTIONS FOR INSTALLATION
REMINDERS FOR THE INSTALLER
The manufacturer will not be liable for any damage or in-
jury resulting from failure to observe the following rules.
-
• Read this manual carefully. It provides important information
for safe installation, use and maintenance of the appliance.
•
authorized by the manufacturer, in compliance with current
safety standards and the instructions given in this manual.
•
detailed on the packaging and on the appliance data plate.
• The appliance must be installed in a well-ventilated room.
• Do not obstruct any air vents or drains present on the ap-
pliance.
• Do not tamper with appliance components.
6 REFERENCE STANDARDS AND LAWS
Install the appliance in compliance with current safety regula-
tions.
7 HANDLING
The packaging is marked with warning symbols that indicate
the precautions to be taken when handling the appliance to
avoid damage. The appliance must only be handledusing su-
itable equipment. If lifting equipment is used, such as forklift
trucks or similar, make sure that the appliance is in a stable
position.
-
5
Publicidad
