Publicidad
Idiomas disponibles
Idiomas disponibles
Step 21
å
With someone's help, center your HUTCH onto the base unit of your choice.
å
Fasten the BRACKET CONNECTORS (81G) to the ENDS (A2 and B2). Use four SILVER 1" LARGE HEAD SCREWS (102S).
å
NOTE: There are no pre-drilled holes in the 427018 or 427163 for attaching the HUTCH. You will need to drill 1/8" wide, 1"
deep holes through the open holes in the BRACKET CONNECTORS (81G).
å
Fasten the HUTCH to the base unit using the newly drilled holes. Use four SILVER 1" LARGE HEAD SCREWS (102S)
through the BRACKET CONNECTORS and into the base unit.
102S
SILVER 1" LARGE HEAD SCREW
(8 used in this step)
1st - Fasten the BRACKET
CONNECTORS to your HUTCH.
81G
2
- Mark and drill 1/8" holes
nd
through the holes in the BRACKET
CONNECTORS and into the base unit.
Page 26
A2
81G
427022
81G
www.sauder.com/service
B2
Publicidad
