Publicidad
Step 12
å
Slide the ADJUSTABLE SHELF MOLDING* (F) onto the
notched edge of the ADJUSTABLE SHELF (E).
å
Push the RUBBER SLEEVES (2R) over one end of the
METAL PINS (1R). Insert the METAL PINS into the hole
locations of your choice in the ENDS (A and B). Set the
ADJUSTABLE SHELF (E) onto the METAL PINS.
å
*U.S. Patent No. 5,499,886
Slide the ADJUSTABLE SHELF
MOLDING (F) onto the notched edge.
www.sauder.com/officeservice
F
These surfaces
should be even.
The groove
is closer to
this edge.
Notched edge
E
B
427835
A
E
1R
(4 used)
2R
Page 19
Publicidad
