Publicidad
Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
HOW TO USE A HIDDEN CAM & CAM SCREW
Cam Screw
Arrow
Hidden Cam
www.sauder.com/officeservice
FASTENER
®
1.
2.
Push a HIDDEN CAM into
the part. The arrow in the
HIDDEN CAM must point
toward the hole in the
edge of the board.
Hole
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Turn the CAM SCREW until
the shoulder is against the
surface of the part.
3.
Insert the CAM SCREW into the HIDDEN CAM.
Tighten the HIDDEN CAM.
1
2
427835
Dowel end
Page 7
Publicidad
