Operation (continued)
4
Adjusting the ON-TIME switch
NOTE: The "ON-TIME" switch determines the amount of
time the light will stay on full bright after all motion has
stopped.
□
When the "On-Time" switch is set to the "20S"
(seconds), "1Min" (minute), or "5Min" (minute)
position, the light will function as a motion
sensing light.
□
Do NOT leave the ON-TIME switch in
the "TEST" position.
2
Brightness
Lo
Med
Hi
6
Using manual mode
NOTE: Manual mode overrides the motion sensor so
the light will operate full bright. This feature only works
at night and only for one night at a time. The motion
sensor will reset to motion sensing mode after 6 hours
or sunrise, whichever comes first. Manual mode can be
toggled on and off using a wall switch.
□
Ensure the power to the light is ON and the
sensor has warmed up (60 seconds).
□
To turn manual mode on, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.
□
To turn manual mode off, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.
Care and Cleaning
□
To prolong the original appearance, clean with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray with a hose or power washer.
On Time
1Min
20S
Eco
Wired: 5min
Test
Solar: OFF
Default
Battery: OFF
5
Adjusting the brightness
switch
This light fixture (B) has an adjustable light level
(lumen) setting. The higher the lumen number, the
brighter the light output. Use the chart below to select
the brightness level desired.
Brightness Setting
Hi (High)
Med (Medium)
Lo (Low)
Eco
Default
NOTE: The "Default" and "Hi" brightness settings are the
same for this model.
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
OFF
ON
Less than 3 seconds
10
Lumen Output
2000
1500
1000
400
2000
OFF
ON