Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
The light will not
come on.
The light comes on
during the day.
The light comes on for
no apparent reason.
The lights stay on
continuously.
The lights flash on
and off.
The lights flash
once then stay off in
manual mode.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit breaker
is turned off.
□
The light fixture is not properly
attached to the mounting base, if this is
a new installation.
□
Daylight turn-off (photocell) is in effect.
□
The circuit wiring is incorrect (if this is
a new installation).
□
The motion sensor is aimed in the
wrong direction.
□
The light fixture is mounted in a dark
location.
□
The motion sensor ON-TIME switch is
set to the TEST position.
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The light fixture is wired through a
dimmer or timer.
□
The motion sensor may be picking up a
heat source, such as an air vent, dryer
vent, or brightly painted, heat-reflective
surface.
□
The motion sensor is in manual mode.
□
The light fixture is wired through a
dimmer or timer.
□
The light fixture is on the same circuit
as a motor, transformer, or fluorescent
bulb.
□
Heat or light from the lamp heads may
be turning the motion sensor on and
off.
□
Heat is being reflected from other
objects and may be turning the motion
sensor on and off.
The motion sensor is detecting light from
the lamp heads.
Solution
□
Turn the light switch on.
□
Replace the fuse or turn the circuit
breaker on.
□
Re-install the light fixture to the base.
□
Recheck after dark.
□
Verify the wiring is correct.
□
Re-aim the motion sensor to cover
the desired area.
□
The light fixture is operating normally
under these circumstances.
□
Turn the control switch to the 20S
(second), 1Min (minute), or 5Min
(minute) position.
□
Reposition the motion sensor.
□
Do not use a dimmer or timer to
control the light fixture. Replace the
dimmer or timer with a standard on/
off wall switch.
□
Reposition the motion sensor.
□
Switch the motion sensor to auto. See
Using manual mode on page 10.
□
Do not use a dimmer or timer to
control the light fixture. Replace the
dimmer or timer with a standard on/
off wall switch.
□
Install the light fixture on a circuit
without motors, transformers, or
fluorescent bulbs.
□
Reposition the lamp heads away from
the motion sensor.
□
Reposition the motion sensor.
Reposition the lamp heads to keep the
area below the motion sensor relatively
dark.
11
Please contact 1-866-308-3976 for further assistance.
HOMEDEPOT.COM
Publicidad
