Defiant DFI-8852-BZ-G Guía Para El Uso Y Cuidado página 6

Installation (continued)
3
Preparing the light for eave
mounting
IMPORTANT: The light fixture and control module will only rotate
one direction. Do NOT FORCE the control module if it does not turn.
□
While holding the light fixture (B) in both
hands, carefully twist the light fixture's control
module (2) 180 degrees as shown.
□
Proceed to step 4, Installing the
mounting bracket.
4
Installing the mounting bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
NOTE: Four mounting bracket screws (BB or CC) of
various sizes are included. The installation will only require
two. Discard the unused mounting bracket screws after
installation.
□
Remove the existing light fixture.
□
Connect the ground wire on the mounting
bracket (EE) to the house ground wire using a
wire connector (AA).
□
Install the mounting bracket (EE) with the
stamped word "FRONT" facing away from
the junction box. Use the mounting bracket
screws (BB or CC) that best fit the junction
box. If necessary, use the screws that were
removed from the existing light fixture.
□
Firmly pull on the mounting bracket (EE) to
verify it is securely mounted to the junction
box.
AA
T
O N
F R
6
180°
2
B
T
O N
F R
BB or CC
EE