Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
5
Wiring the mounting base
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
NOTE: If necessary, strip 3/8 in. of insulation from
junction box wires.
□
Hold down the "paddle" on the top of the pre-
installed quick connect (3) located on the back
of the mounting base (D).
□
Insert the junction box wires (4) into the quick
connect (3). Ensure the white (N – Neutral)
wire is across from the pre-installed white
wire and the black (L – Line) wire is across
from the pre-installed black wire.
□
Release the "paddle" and gently tug on the
wires (4) to ensure that they are securely
connected.
6
Installing the mounting base
□
Place the mounting base (D) against the
junction box. Ensure the wires are pushed up
into the junction box.
□
When mounting to a wall, the "UP" arrow
must point upward.
□
When mounting to an eave, the "UP" arrow
must point toward the building.
□
Insert the mounting bolt (DD) through the
mounting base (D) hole and thread it into the
center hole of the mounting bracket (EE).
Tighten the bolt (DD) securely.
D
□
Firmly pull on the mounting base (D) to
verify it is securely attached to the mounting
bracket (EE).
DD
7
Please contact 1-866-308-3976 for further assistance.
3/8"
3
EE
D
HOMEDEPOT.COM
4
Publicidad
