Descargar Imprimir esta página

Defiant DFI-8852-BZ-G Guía Para El Uso Y Cuidado página 9

Luz de seguridad por movimiento

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
1
Adjusting the lamp heads
WARNING: Risk of fire. Keep the lamp heads at least
2 in. (51 mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
Ensure the power is turned on for the light (B).
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
A
3
Adjusting the motion sensor
detection zone
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
Watch the light (B). The light will come on
indicating motion has been detected.
Stop, wait for the light to turn off, and then
begin walking again.
Continue this process until the detection zone
has been established.
If needed, gently grasp the motion sensor (C)
and move it from side to side or up and down
to adjust the detection zone.
Note: Moving the motion sensor (C) "UP"
increases the distance of the detection
zone. Moving the motion sensor (C)
"DOWN" decreases the distance of the
detection zone.
There are built-in stops in the motion sensor (C). Do
not rotate the motion sensor (C) past these stops.
2
Setting the sensor for testing
NOTE: When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day or
night. The light will stay on for 8 seconds after all motion
is stopped.
Set the "ON-TIME" switch to the "TEST"
position.
Set the "Brightness" switch to the "Default"
position.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
2
Brightness
Lo
Med
Hi
9
Please contact 1-866-308-3976 for further assistance.
On Time
1Min
20S
Eco
Wired: 5min
Test
Solar: OFF
Default
Battery: OFF
C
C
C
HOMEDEPOT.COM

Publicidad

loading

Este manual también es adecuado para:

Dfi-8852-wh-g10071293991007129810