Parkside 20 M PLEM 20 A4 Instrucciones De Utilización Y De Seguridad página 51

Note: If laser beam is already activated,
the above mentioned step can be skipped.
Now aim the laser at the target point. Briefly
press the MEAS button again. If the meas-
4
urement is successful the measured value will
be shown on the bottom line of the display
and the laser beam will be turned off.
3
If needed to measure another distance,
repeat above steps.
Newly measured value will be shown on
the bottom line of the display and the
3
previous measured value will be shown
in the middle of the display . Now, the
3
laser beam will be turned off.
GB/IE 51