Measurement At The Temple - NUK 10.256.345 Operación Manual

4. Carefully guide the probe head 5 into the
ear canal until it rests on the ear canal
(see figure E and F).
5. Press and hold the SCAN button 2 until
you hear a beep.
6. Remove the probe head 5 from the ear
canal.
The egg-timer
displayed and stops flashing after
about 4 seconds. Two short
beeps indicate that the result has been
determined.
7. Read off the measured result in the LCD
display 3.
The device automatically switches to
room temperature mode after approx.
one minute.

5.4 Measurement at the temple

Make sure the temples are dry, clean and
free from make-up when taking the
symbol is
- 40 -
temperature. Avoid placing the device on
any scarred areas.
1. Press the Standby (ON/MEM) button 7 to
switch on the device.
The adjacent symbol will appear
in the LCD display 3 and you will
hear two beeps.
2. Remove the cover 1 from the probe
head 5 (see figure C).
3. Press and hold the Stand-by (ON/MEM)
button 7 and, at the same time, press the
SCAN button 2 once.
The temples symbol will appear
on the LCD display 3. The
"temple measurement mode" is
thus activated, used for reading the
temperature at the temples.
4. Touch the skin on the right or left temple
with the sensor lens 4 of the
thermometer (see figure G).