Carson Reflex Wheel Pro Instrucciones página 21

Operating Procedure
Many publications say that the setup sequence
for the transmitter and receiver don't play a role
anymore with 2.4 GHz sets. However, we recom-
mend sticking to the sequence typical for previous
sets.
• Before operation: First turn on the transmitter,
then the receiver. Lastly, connect the drive bat-
tery to the control unit.
BEC-System/Connections to Receiver
BEC-receiver:
Battery eliminator is installed in the receiver
circuitry. The receiver gets supplied with current
through the drive battery that runs the engine.
NiMH battery from 6 V to 8.4 V can be used for
Electronic speed controller
(not included)
Receiver
Do not connect a separate power
supply to the receiver!
CARSON Reflex Wheel Pro LCD 2,4 GHz 50 050 0033
All manuals and user guides at all-guides.com
• After operation: Disconnect the battery from the
• Before and after operating the transmitter, make
the receiver. Batteries of higher voltage may
damage the receiver and servos.
Use only a speed controller which has the exclusive
connector for the BEC system.
control unit. Turn the receiver off, and then the
transmitter.
sure that trim is in the desired place and that all
checks have been made.
Connector motor
Connector battery
Power switch On-/Off
Steering servo
channel 1
(not included)
ATTENTION
Make sure that male and female connectors
have the correct polarity!
GB
21