Publicidad
Idiomas disponibles
Idiomas disponibles
Common Issues
Problem
Scheduled Cleaning is not working
Is power always being drawn when
the robot is on the dock?
Does the robot need to be
charged for at least 16 hours for
the first three uses?
No or little water during mopping
Too much water during mopping
Cleaning does not resume after
recharging
The robot cannot return to the
dock after spot cleaning or when it
has been moved manually
The robot begins to miss certain spots
Solution
• Battery low. Scheduled cleaning can only begin when the battery level is above 20%.
• The robot will draw power while it is docked to maintain battery performance, but the
power consumption is extremely low.
• No. The lithium-ion battery has no memory effect. The robot can be used any time after it
has been fully charged once.
• Check whether there is water in the water tank; adjust up the water flow; wash the mop
cloth; replace the filter; check the manual for instructions on how to correctly install the
mop.
• Make sure that the water tank stopper is properly installed; adjust down the water flow;
make sure that the filter is properly installed.
• Make sure that the robot is not in DND mode. DND mode will prevent auto top-up. If the
robot is placed manually on the dock before it is recharged automatically, it will not be
able to continue cleanup.
• After spot cleaning or a significant position change, the robot will re-generate the map. If
the dock is too far away, the robot may not be able to return for recharging and must be
placed on the dock manually.
• The wall sensor or cliff sensors may be dirty. Clean them with a soft, dry cloth.
13
Publicidad
