Bimar HR309 Manual De Instrucciones página 14

 Should the appliance fall or malfunction, immediately
disconnect the plug from the plug point. Check that it is not
damaged, and thereafter turn it back on: if in any doubt, consult
a qualified professional.
 If the appliance is not being used, unplug it from the plug point.
 WARNING: in order to avoid overheating, scalding or fires, do
not cover the appliance.
INSTALLATION
 After unpacking, check the integrity of the appliance; if in doubt, do not use it and
contact a qualified technician.The packaging materials (plastic bags, polystyrene,
metal staples, etc.) must not be left within reach of children, as they are potentially
hazardous.
 Before installing the appliance, make sure that:
- the electrical system to which the appliance will be connected complies with current
standards and has cables whose cross-section is suitable for the absorbed power
- the voltage values on the nameplate correspond to those on the mains supply.
Check that other appliances with high absorption are not connected to the power line
to avoid overloading and fire hazards. In the event of incompatibility between the
power socket and the appliance's plug, have the plug replaced with a suitable model
by a qualified professional, who should ensure that the cable is appropriate for the
power rating of the device. The use of adaptors or extensions is generally not
advisable; if it is necessary to use them, they must comply with safety regulations and
the total current (amperes) must not be rated lower than the maximum current of the
appliance.
- There are no water, gas or power lines inside the wall
- The wall to which the appliance is to be fixed must be made of masonry and/or
heat-resistant, fire-retardant and solid material (not wood or synthetic material), flat
and free of irregularities; the ceiling must also be made of fire-retardant and heat-
resistant material.
- the appliance can be installed at least 220cm from the ground (height referred to
the lower edge of the appliance), is positioned so that it cannot suffer impacts and
that the radiating part has a free space of at least 100cm, and at least 50cm at the
sides.
- the appliance is away from other sources of heat, flammable materials (curtains,
upholstery, etc.), flammable gases or explosive materials (spray cans) and materials
that can be deformed by heat.

This appliance must not be used in any type of vehicle or restricted space (lifts,
camper vans, cars, cabins etc.).

Ensure that the power cable is correctly positioned and does not come into
contact with hot parts or sharp edges, or become wound around the device itself
and is not twisted.
14