Bosch TT 018 Instrucciones De Servicio página 9

1 609 929 C65 - Buch Seite 1 Mittwoch, 11. August 2004 1:16 13
Tool Specifications
Cutting TT 018
grinder Stand
Article number 0 601 999 018 0 601 999 019
Clamping
width max. 110 mm
Cutting depth:
Cutting
disc Ø 230 mm 60 mm
Cutting
disc Ø 180 mm 30 mm
Machine Elements
The numbering of the machine elements refers to
the illustration of the machine on the graphics
page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Tilting lever*
2 Hexagonal bolt
3 Length stop (1 607 000 200)***
4 Spark guard
5 Clamping lever
6 Quick-release vice
7 Cutting angle scale
8 Fastening bolt
9 Slotted bushing with spring
10 Allen key
11 Clamping device
12 Adjustment screw
13 Extraction neck (for hose Ø 19 mm)**
14 Stop pin
* With short threaded bolt in France
** Only for France
*** Not all of the accessories illustrated or described are
included as standard delivery.
Intended Use
The unit is intended to be used with angle grind-
ers with a disc diameter ranging from 180 to
230 mm. It is suitable for clamping and rectangu-
lar cutting of steel and masonry profiles.
9 • 1 609 929 C65 • TMS • 15.07.04
TT 019
(Only for
France)
110 mm
The safety notes and operating instructions
60 mm
for the power tool being used are to be strictly
observed!
30 mm
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of ma-
terials are particularly dangerous.
Secure stand to workbench by fastening with
screws.
Always clamp the workpiece to be machined.
Long workpieces must be underlaid /sup-
ported at their free end.
Only clamp or unclamp workpiece when the
cutting disc is not in motion.
For all work with the grinder stand, the spark
guard 4 must be mounted.
Observe dimensions of cutting disc.
The cutting disc must not touch the base plate
when lowering it.
Cut workpiece applying only moderate pres-
sure and using one hand.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
English - 1
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. Before using
for the first time, ask for a practi-
cal demonstration.
Wear protective glasses and hear-
ing protection.
Dust developing during machining
is harmful to one's health. Wear
dust respirator!
Wear protective gloves and sturdy
shoes.
When necessary, also wear an
apron.