GYS SMART HUB MODULE Manual De Instrucciones página 12

Operating manual
MULTI-MODULE CONFIGURATION
The Smart Hub Module (SHM) is an accessory that allows several modules (maximum 4) to be connected to a single
Gysflash CNT charger.
Set up
For the SHM device to work, a GYSFLASH CNT charger must be connected to channel 1 (FIG II) via the
SMC cable supplied.
Can be used with or without power cable
This device is supplied with a 16 A CEE7/7 plug and must only be used in a single-phase 230 V (50 - 60 Hz)
three-wire electrical installation that includes an earth.
• If there are as many (or more) chargers as there are modules connected to the SHM, then a mains supply is
not required. Each Gysflash can supply power to the module connected to its respective channel.
To draw power from a charger, the module must be connected to the same channel as a Gysflash.
In Multi-Charger configuration, it is not necessary to connect the SHM mains lead.
• If there are more modules than chargers connected to the SHM, it is necessary to connect the
SHM's mains cable in order to activate all the channels.
To check that the channel corresponding to a
module is activated, confirm that the associated
LED is lit.
Usage
Make sure that the Gysflash and the modules are properly connected to the SHM (see Installation section above).
1
Switch on the Gysflash and, if necessary, connect the SHM to the mains power.
2
Make sure that the LEDs corresponding to the different modules are illuminated.
3
The Gysflash is now ready to be used in conjunction with the attached modules.
4
12
Translation of the original
instructions
1 module

SPM
Several modules
SLM
SHM
SUM
SMART HUB MODULE

SPM