6.3 OPERATING THE LIGHTS
6.4 RAISING THE TOWER (MANUAL WINCH SYSTEM)
Procedimiento
MULTIFUNCTION FLOODLIGHT TOWER
The circuit breaker directly controls 4 LED lights. Switch the circuit breaker to "ON"
position. LED lamp energizes instantly,switch the circuit breaker to "OFF" position. LED
lamp de-energizes instantly.
Perform the procedure below to raise the tower in manual winch system.
¡WARNING!
NEVER raise the tower or operate the Light Tower in high winds. Make sure the
generator or counterweight on the frame is within 50 - 85 kg range before operating the
machine.
NEVER raise the tower while the generator is running.
Do not move the Light Tower while it is operating or mast is up.
WARNING!
HIGH VOLTAGE! DO NOT use the Light Tower if insulation on electrical cord is cut or
worn through. Repair or replace the cord before using. Bare wires in contact with the
metal frame of the trailer or tower can cause electrocution.
WARNING!
NEVER allow anyone to stand near the rear of the unit while raising the tower.
The Light Tower includes a winch for raising and lowering the tower.
The winch is an automatic brake-type that automatically brakes when the han¬dle is
released. The handle must be rotated to wind in the cable as well as to unwind the
cable.
en
STELLA
23