Descargar Imprimir esta página

ResMed Power Station II-V2 Guia Del Usuario página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 157
Refer to illustration E.
1.
Select the correct output voltage for your device using the voltage output selector
from the battery pack rear panel.
2. Connect the appropriate DC cable to the battery pack.
3. Connect the other end of the DC cable to the device.
4. Connect the AC power cord to the rear of the device.
5. Plug the other end of the AC power cord into the mains power outlet.
6. Set the DC on / off switch to on.
Notes:
When powering the device regularly check the battery pack charge level.
In the event you notice any unexplained changes in the device (battery pack /
coupler kit / PSU adaptors / DC cables), signs of degradation that affect
performance, or if the enclosure is broken, discontinue use and contact your
healthcare provider.
Using two batteries
Refer to illustration F.
1.
Place one battery pack on top of another.
If required, use the Velcro strap to hold the battery packs securely.
2. Plug the battery pack coupler cables into each of the DC input / output ports. The
battery pack coupler cables are marked with '1' (primary) and '2' (reserve) labels.
3. When charging two battery packs, attach the power supply unit adaptor to the DC
plug and connect the adaptor to the battery pack coupler.
When powering a device, connect the DC cable of the device to the end of the
battery pack coupler. The primary battery pack supplies power to the device and
the reserve battery pack takes over when the primary battery pack is disconnected
or discharged.
Indicators
Refer to illustration B.
The battery pack provides LEDs to indicate its current operating state.
LED indicator
Battery pack charge level
One amber flashing (audible
alert beeps continuously)
One green flashing (audible alert
beeps for 10 sec)
One green continuous
Two green continuous
Three green continuous
Four green continuous
Charging (B-7)
Status
(B-6)
1
Less than 5%
Less than 10%
10% to 40% (approximate)
40% to 65% (approximate)
65% to 90% (approximate)
Greater than 90% (approximate)
English 3

Publicidad

loading

Productos relacionados para ResMed Power Station II-V2

Este manual también es adecuado para:

Rpsii-v2