Overload Protector - Makita SP6000 Manual De Instrucciones

Speed adjusting dial
► 1. Speed adjusting dial
The tool speed can be adjusted by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 6; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Number
1
2
3
4
5
6
CAUTION:
• The speed adjusting dial can be turned only as
far as 6 and back to 1. Do not force it past 6 or
1, or the speed adjusting function may no longer
work.
• The speed adjusting dial is not for using low
speed rated saw blades but for obtaining a
speed which is suitable to material of workpiece.
Use only saw blades which are rated for at
least the maximum no load speed stated in the
SPECIFICATIONS.
The tools equipped with electronic function are easy to
operate because of the following features.

Overload protector

When the tool is overloaded and current flows above
a certain level, the tool automatically stops to protect
motor.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
Soft start feature
Soft start because of suppressed starting shock.
1
► 1. Hex wrench
Hex wrench is stored on the tool. To remove hex
wrench, just pull it out.
/min (RPM)
To install hex wrench, place it on the grip and insert it as
2,200
far as it will go.
2,700
3,800
4,900
6,000
6,400
To remove the blade, push in the lock-off button to
unlock the upper limit stopper.
► 1. Lock-off button 2. Locking lever
Turn the locking lever to lock the saw head for replacing a blade.
8 ENGLISH
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Hex wrench storage
Removing or installing saw blade
CAUTION:
• Do not use saw blades which do not comply
with the characteristics specified in these
instructions.
• Use only saw blades which are rated for at
least the maximum no load speed stated in the
SPECIFICATIONS.
• Be sure the blade is installed with teeth pointing
up at the front of the tool.
• Use only the Makita wrench to install or remove
the blade.
2
1
1