Publicidad
Idiomas disponibles
Idiomas disponibles
• Trim even young plants to the desired shape. The
main shoot should remain undamaged until the
hedge has reached the planned height. All other
shoots are cut in half.
9.3
Maintaining free-growing hedges
Although free-growing hedges are not pruned, they
must be maintained regularly to prevent the hedge from
becoming too tall.
9.4
Cut at the right time
• Leaf hedge: June and October
• Conifer hedge: April and August
• Fast growing hedge: around every 6 weeks from
May
Pay attention to nesting birds in the hedge. Delay the
hedge cut or leave this area out if this is the case.
10 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always perform
maintenance and cleaning work with the
battery removed. There is a danger of inju-
ry! Let the Product cool down before all
maintenance and cleaning tasks. Elements
of the engine are hot. There is a danger of
injury and burning!
The product can start unexpectedly and cause inju-
ries.
–
Remove the battery.
–
Allow the product to cool down.
–
Remove the tool attachment.
CAUTION
Wear protective gloves when handling the
blades!
10.1
Cleaning
1. Wait until all moving parts have come to a standstill.
2. Clean the cutter bar with an oily cloth after each
use.
3. Oil the cutter bar after each use with the oil can or a
spray.
4. Never immerse the product in water or other liquids
for cleaning.
5. Do not splash the product with water.
6. Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure. We recommend
that you clean the product directly after every use.
7. Ventilation openings must always be free.
8. Do not use any cleaning products or solvents; they
could attack the plastic parts of the product. Make
sure that no water can penetrate the product interi-
or.
10.2
Maintenance
1. Check the product for obvious defects such as
loose, worn or damaged parts before each use.
2. Check that the screws in the cutter bar are tight.
3. Check the covers and protective devices for dam-
age and correct seating. Replace them if necessary.
4. You can smooth out slight nicks on the cutting teeth
yourself. To do this, draw an oil stone along the cut-
ting edges. Only sharp cutting teeth provide a good
cutting performance.
5. Blunt, bent or damaged cutter bars must be re-
placed.
11 Storage
Preparation for storage
1. Remove the battery.
2. Clean and check the product for damage.
3. For transport or when storing the product, cover the
blade with the blade guard.
4. Fertiliser and other garden chemicals contain sub-
stances that can have a severely corrosive effect on
the metal parts. Do not store the product in the vi-
cinity of these substances.
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
12 Repair & ordering spare parts
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
www.scheppach.com
GB | 25
Publicidad
