Publicidad
Idiomas disponibles
Idiomas disponibles
14 Troubleshooting
Fault
The product cannot be started. The battery power is too weak.
Product works with interrup-
tions.
Cutter bar becomes hot.
Poor cutting results
15 Warranty conditions – gomag
20V series
Revision date 11/07/2023
Dear customer,
our products are subject to strict quality checks. How-
ever, if a product does not function perfectly, we deeply
regret this and ask that you contact our customer ser-
vice at the address specified below. We will also be
glad to assist you by telephone via the service number.
The following information is intended to help you to pro-
cess and settle your claim without any problems.
For the assertion of warranty claims, the following
applies:
1. The warranty conditions govern our additional
manufacturer warranty services for purchasers (pri-
vate end consumers) of new products. The statutory
warranty claims are not affected by this warranty.
This is the responsibility of the dealer who you pur-
chased the product from.
2. The warranty service extends exclusively to de-
fects in a new product purchased by you that are
based on a material or manufacturing fault and is, at
our discretion, limited to the repair of such defects
free of charge or the replacement of the product (al-
so replacement with a successor model, if neces-
sary). Replaced products or parts shall become our
property. Please note that our products were not
designed for commercial, trade or professional use.
A warranty claim is therefore not valid if the product
has been used in commercial, trade or industrial op-
erations within the warranty period or has been sub-
jected to equivalent stress.
Possible cause
The battery is not properly inserted. Push the battery into the battery mount. The
Safety switch not actuated.
On/off switch defective
Motor defective.
Internal loose contact.
On/off switch defective
Cutter bar blunt.
Cutter bar has nicks.
Too much friction due to lack of lu-
brication.
Cutter bar blunt.
Too much friction due to lack of lu-
brication.
Dirty cutter bar.
Poor cutting technique.
www.scheppach.com
Remedy
Charge the battery.
battery clicks into place audibly.
Switch the product on.
Please contact our service department.
Please contact our service department.
Check cutter bar, sharpen or contact our ser-
vice department.
Oil the cutter bar.
Check cutter bar, sharpen or contact our ser-
vice department.
Oil the cutter bar.
Clean the cutter bar.
Observe the working instructions.
3. The following are excluded from our warranty
services:
– Damage to the product which was caused by
non-observance of the assembly instructions,
improper installation, non-observance of the op-
erating instructions (e.g. connection to an incor-
rect mains voltage or type of current) or the
maintenance and safety regulations or use of
the product in unsuitable environmental condi-
tions as well as by insufficient care and mainte-
nance.
– Damage to the product caused by misuse or im-
proper application (such as overloading the
product or using non-approved tools and acces-
sories), penetration of foreign bodies into the
product (such as sand, stones or dust), trans-
port damage, use of force or external influences
(such as damage caused if dropped).
– Damage to the product or parts of the product
which is due to intentional, normal (operational)
or other natural wear as well as damage and/or
wearing of wear parts.
– Defects in the product which have been caused
by the use of accessories, expansions or spare
parts that are not original parts or are not used
as intended.
– Products on which changes or modifications
have been made.
– Minor deviations from the target characteristics
which are irrelevant for the value and usability of
the product.
GB | 27
Publicidad
