Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: TO
AVOID
SERIOUS
INJURY,
BEFORE
PERFORMING
ANY SER-
VICE OR ADJUSTMENTS:
1.
Depress
brake
pedal fully and set parking
brake.
2.
Place
attachment
clutch
in "DISENGAGED"
position.
3.
Turn ignition
key to "STOP"
and remove
key.
4.
Make sure the blades
and all moving
parts have completely
stopped.
5.
Disconnect
spark
plug wire from spark
plug and place
wire where
it cannot
come
in contact
with plug.
TRACTOR
TO REMOVE
MOWER
1. Place
attachment
clutch
in "DISEN-
GAGED" position.
2. Lower attachment
lift lever to its lowest
position.
3. Roll belt off engine pulley (M).
4. Remove retainer spring (K), slide collar
(L) off and push housing guide (P) out
of bracket.
5. Remove clutch cable spring (Q) from idler
arm (R).
6. Disconnect
front
link (E) from mower
- remove retainer spring and washer.
7. Go to either side of mower and discon-
nect mower suspension
arm (A) from
chassis pin (B) and rear lift link (C) from
rear mower bracket (D) - remove retainer
springs and washers.
8. Go to other side of mower and disconnect
_the
suspension
arm and rear lift link.
CAUTION:
After rear lift links are discon-
nected, the attachment lift lever will be spring
loaded. Have a tight grip on lift lever when
changing position of the lever.
9. Slide mower out from under right side of
tractor.
IMPORTANT:
If an attachment
other than
the mower is to be mounted on the tractor,
remove
the front link (E) and rear lift liks
(C) from tractor and hook the clutch spring
(Q) into the cable guide on front edge of
lower dash.
TO INSTALL
MOWER
Be sure tractor
is on level surface
and engage
parking
brake.
1.
Lower
attachment
lift lever to it's lowest
position.
A
CAUTION:
Lift lever
is spring
loaded.
Have a tight grip on lift lever, lower
it slowly
and engage
in lowest
position.
NOTE:
Be sure
mower
side
suspension
arms
(A) are pointing
forward
before
sliding
mower
under tractor.
2.
Slide mower
under tractor
until it is cen-
tered
under tractor.
3.
ATTACH
MOWER
SIDE SUSPENSION
ARMS
(A) TO CHASSIS
- Position
hole
in arm over
pin (B) on outside
of tractor
chassis
and
secure
with
washer
and
retainer
spring.
4.
Repeat
on opposite
side of tractor.
\
2O
03042
Publicidad
