Descargar Imprimir esta página

Craftsman 917.28824 Manual Del Propietário página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

TO LEVEL MOWER
Make sure tires are properly inflated to the
PSI shown on tires. Iftires are over or under
inflated, it may affect the appearance of your
lawn and lead you to think the mower is not
adjusted properly.
VISUAL
SIDE-TO-SIDE
ADJUSTMENT
1.
With all tires properly
inflated
and if your
lawn
appears
unevenly
cut,
determine
which
side of mower
is cutting
lower.
2.
With a 3/4" or adjustable
wrench,
turn lift
link adjustment
nut (A) to the left to lower
LH side of mower,
or, to the right to raise
LH side of mower.
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck
must
be level
side-
to-side.
To obtain
the best cutting
results,
the mower
blades
should
be adjusted
so the front tip is
1/8" to 1/2" lower than the rear tip when the
_lbower is in its highest
position.
CAUTION:
Blades
are
sharp.
Protect
your
hands
with gloves
and/or
wrap
blade
with heavy cloth.
Raise
mower
to highest
position.
Position
any blade
so the tip is pointing
straight
forward.
Measure
distance
(B)
to the ground
at front and rear tip of the
blade.
Turn nut rig
to raise mower
Turn nut left
to lower mower
NOTE:
Each full turn of adjustment
nut will
change
mower
height
about
3/16".
3.
Test your
adjustment
by mowing
some
uncut
grass
and
visually
checking
the
appearance.
Readjust,
if necessary,
until
you are satisfied
with the results.
PRECISION
SIDE-TO-SIDE
ADJUSTMENT
1.
With all tires properly
inflated,
park tractor
on level ground
or driveway.
CAUTION:
Blades
are sharp.
Protect
your
hands
with gloves
and/or
wrap
blade
with heavy
cloth.
2.
Raise mower
to its highest
position.
3.
At both sides of mower,
position
blade at
side and measure
the distance
(A) from
bottom
edge of blade to the ground.
The
distance
should bethesameon
both sides.
/,fWI A
4.
If adjustment
is necessary,
see step 2 in
Visual
Adjustment
instructions
above.
5.
Recheck
measurements,
adjust if neces-
sary until both sides are equal.
If front tip of blade is not 1/8" to 1/2" lower
than the rear tip, go to the front of trac-
tor.
• With
an 11/16"
or adjustable
wrench,
loosen jam nut A several turns to clear
adjustment
nut B.
• With a 3/4" or adjustable
wrench,
turn
front link adjustment
nut (B) clockwise
(tighten) to raise the front of mower, or,
counterclockwise
(loosen)
to lower the
front mower.
NOTE:
Each full turn of the adjustment
nut
will change mower height about 1/8".
Recheck measurements,
adjust if neces-
sary until front tip of blade is 1/8" to 1/2"
lower than the rear tip.
Hold adjustment nut in position with wrench
and tighten jam nut securely against ad-
justment nut.
Tighten adjust nut
B to raise mower
Loosen adjust
nut B to lower
mower
22
Loosen jam nut A first

Publicidad

loading